|
LONG OVERDUE
Since the invention of stainless
braided hose, racers and mechanics have been fighting the problem of
installing it into the socket part of the assembly. If your lucky
and get a clean cut on the end of that hose, you might get it in.
Most of the time a little fuzz appears on the hose end and the
battle begins. It is not only time consuming, it can get bloody.
KOUL tools has delivered a solution that makes the assembly a snap.
Manufactured of a high tech composite, it is virtually
indestructible. No need to worry about vise marks or wearing out.
Just insert the socket into the tool, twist the hose in, and in less
than 10 seconds you have it assembled. You can repeat this several
times without recutting the hose end. The tool can pay for itself
the first time you don't have to scrap some hose because it got too
short trying to clean up the end. You'll be amazed at the amount of
time you'll save. After using this tool, you will say to yourself, "KOUL".
The Small Kit (#486)
Contains the capsules to install -4, -6, and -8 hose into
their respective sockets. To accommodate all the different
manufacturer's fittings, spacers and sleeves are required to tighten
up some of the sockets within the capsule. In the small kit, only
the Russell-4 needs a sleeve. The #8 spacer is used for the -8
sockets.
$75.00
Each |
 |
|
|
The
Large Kit (#1016)
Contains the capsules to install -10, -12, and -16 hose
into their respective sockets. To accommodate all the different
manufacturer's fittings, spacers and sleeves are required to tighten
up some of the sockets within the capsule. For the tool to perform
at it's best, the socket needs to be a snug fit within the capsule.
In the large kit, all the -16s except Russell's require the sleeve
and a rear spacer. See the instructions in the case for the proper
spacer number. Most of the #10s will use the #10 spacer.
$90.00
Each |
|
|
|
|
|
 |
|
| |
 |
© 2010 finneys.com all rights reserved |
|
